Issue:
Setting a GPIO pin to output a signal using DCAM v1.31 strobe functionality.

Solution:

The purpose of the following Technical Application Note is to provide the user with information on how to configure a GPIO pin to output a signal of user-defined delay and duration using the DCAM v1.31 strobe output functionality.

Related Articles:
1.) Determining the firmware version used by a PGR camera.
2.) Where can I find a copy of the IIDC 1394-based Digital Camera (DCAM) Specification?
3.) Setting a GPIO pin to output a strobe signal pulse pattern.
4.) GPIO strobe signal continues after isochronous image transfer stops.
5.) New GPIO pin functionality in Flea2 FL2G-xx and Ladybug3 models